![]() ![]() ![]() Re-check that your pins are in the correct settings and always set the amps required to the closest needed but not exceeded (ex. If the motor starts acting rough or is excessively trying to move without physically moving the input shaft. Any ideas what would most likely cause this? Current Solution However, all the connections and wires are in tact. It is wired bipolar series, and was working great but then in the midst of a cutting operation the stepper started sounding rough- as though one of the phases was shorting out. The X-axis stepper motor on my BlackToe suddenly started acting up. ![]()
0 Comments
Leave a Reply. |